i30 Owners Club

FD main beam lower than dip beam????

0 Members and 1 Guest are viewing this topic.

Offline rcflyers

  • 2nd Gear
  • *
    • Posts: 96

    • gb United Kingdom
      UK
I have fitted a HID dip beam system and when driving home last night noticed that when I put my main beam on the main beams appeared slightly lower than the dip beams!

Is there any way of adjusting the main beams up?

Or do I have to adjust the dip beams down and then raise the whole lot using the adjuster in the car?

Thanks.
  • Getz i30


Offline The Gonz

  • Admin
  • *
  • Afghanistan Vet
    • Posts: 16,734

    • au Australia
      Adelaide

  • Callsign GUNZ
Not knowing any more detail, I would assume your latter option is the right one if both beam systems are housed in the one enclosure. :goodjob:
  • Frugal Firty: FDSLXCRDi5spHyperSilverBodyKit+Mods & MrsG'sPDSRPrem


Offline Just Rick

  • V.I.P
  • *
  • Big Dogs Rule
    • Posts: 7,617

    • au Australia
      Beverley Western Australia

  • miracles can happen
Just reading what you have wrote and how Ihave under stood it,it almost sounds as if the Low beam bulbs are not seated correctly,the only other explaination is that HID but out a totally different type of light and will go further than Holagen globes.

Both high and low beam are adjusted at the same time in the FD
  • 2011 SLX CRDI 6 Spd, 2010 Holden Cruze CD Diesel and 2001 Hyundai Accent Coupe


Offline baroudeur

  • 5th Gear
  • *
    • Posts: 678

    • gb United Kingdom


Both high and low beam are adjusted at the same time in the FD

By the dashboard adjuster.

They can also be adjusted individually at the lamps.  Each lamp has two holes through the valance  marked <U   D> and <R   L> for a screwdriver to turn the bevel gear adjusters.

In the OP's case it seems the fitting of the HIDs has mis-aligned the setting.


Offline rcflyers

  • 2nd Gear
  • *
    • Posts: 96

    • gb United Kingdom
      UK
I removed one of the headlamp units earlier and was looking at the adjuster mechanisms.

It seems that when you adjust the up and down either manually on the adjuster or from inside the car it moves both the dip beam and main beam units together.

Not sure how I am going to get around this problem yet.
  • Getz i30


Offline Asterix

  • V.I.P
  • *
  • i40 CRDi 100kW 2013
    • Posts: 4,434

    • dk Denmark
      Sdr. Omme - DK
Yes, you can only adjust the complete headlight assembly.

1 screw adjust the assembly sideways, the other one adjusts up/down.
  • i40 CRDi 100 kW 2013


Offline baroudeur

  • 5th Gear
  • *
    • Posts: 678

    • gb United Kingdom
I removed one of the headlamp units earlier and was looking at the adjuster mechanisms.

It seems that when you adjust the up and down either manually on the adjuster or from inside the car it moves both the dip beam and main beam units together.

Not sure how I am going to get around this problem yet.

It would appear that the HID bulb is not seated correctly or has an off centre light output.

How an ellipsoidal light works ........  :link: Ellipsoidal (DE) System - Hella


Unread Posts

 


SimplePortal 2.3.5 © 2008-2012, SimplePortal