Tha Original i30 Owners Club
MODIFYING OR DETAILING YOUR I30 => ELECTRICAL | ELECTRONIC | AUDIO => Topic started by: i30pom on January 19, 2025, 06:48:54
-
My i30 2014 GD-01 headunit died some time ago and after much pondering I decided to replace it with an aftermarket Android Eonon UA13 Plus. I have this installed using just the ISO primary Harness and an aerpro facia. It all works great and is good value.
I knew prior to installing it that the SWC controls would not work unless I bought the expensive $100+ aerpro harness + patch cable or hardwire the SWC wire to the headunit directly and then program the controls via the unit. To keep costs down I would like to go with option 2.
I am trying to locate the SWC wire on the car side and using the GD-01 wiring diagram I have identified pins 22 (ST-REMO) and 35 (REMO-GND).
The UA13 Plus has two loose SWC 1 and SWC 2 wires and a GND wire which is connected to another plug or another which is for use with the reverse camera, which I will install shortly.
My question is I assume HU SWC 1 needs to be spliced to i30 ST-REMO pin 22 but I am unsure about the i30 REMO-GND pin 35 and if this needs to be wired anywhere and if so, should this be spliced into a HU GND?
Thanks!
-
in case it helps anyone in the future. No need to buy the expensive SWC harness...I preserved my steering wheel controls by connecting car side pins 22 (ST-REMO) to the headunit's SWC 1 wire and pin 35 (REMO-GND) to the headunit's GND. I just had to use the steering control learning in the headunit.
-
thanks for the post, Im looking for some coinfirmation on something similar.
I have installed the Sony XAV-AX3200 , and it comes with a steering wheel plug , the RC-SR1.
For my car , the pins i need appear to be Connector B Pin 5 "steer Key " , and Connector B Pin 17 for ground "Steer Key Ground.
I'll upload a picture when i get home.
Does that seem about right? And use the resistive learn function to program the keys?