Another mod to cross of my list! I have installed electric folding mirrors onto my hatch
Started off with purchasing 2 x folding mirrors from a i30cw
master switch and bezel from a i30cw
side mirror connector plugs from cw
and and auto folding mirror relay kit
This was not just a "plug and play" job the electrical wires that are in the CW for the folding mirrors are not in the hatch. The relay kit helps a lot because rather then trying to insert wires into a plug it provides a plug with wires that just need to be connected if that makes sense...
I didn't write down the exact wiring specifics. However for anyone who is wanting to do the same, this is a guideline of what needs to be done.
-First I swapped the covers from my mirrors with the covers on the CW electric fold mirrors, this of course is optional.. while I like the led indicator that the CW mirrors have I didn't want to have and indicator both on the mirror and the fender (and not prepared to shave of the fender indicator or swap fenders with a cw). Also I didn't have to worry about finding the same colour mirrors from a CW
-Install the electric folding mirrors, cut off the original mirror plug and solder those wires to the CW mirror plug (there will be 4 this is the mirror adjusting wires, they will have the same locations) this will leave 3 wires from the CW plug (mirror in, mirror out and led indicator signal)
-install CW master switch and connect relay between master switch and master switch plug
-connect a constant 12v to the red wire in the relay kit (has to be brought from inside, no constant 12v in door)
-find which wires are not being used in the relay kit and test to find folding in/out signals
-wire in/out signals to the folding mirror and same signal wires to the passenger mirror (PITA)
That's pretty much it, if your good enough with a multimeter then you should be able to do it (I did haha)
