[ElleB]

HI All,
 I am trying to complete my installation of my Dash Commander data logger and display.

There are a number of parameters that I want to put into the program to achieve as good and accurate results as possible.
 I need the below....I am away on holidays and have very limited access to internet....so am limited in research capability.

I am hoping to fiddle and get the program set up while I have a few days free away from business and home, so any help will be greatly appreciated.

I was looking for :
Drag Co Eff
Frontal Area
Tyre rolling resistance co eff   (Original Kumho)
Lambda  -actual and commanded
MAF PID
MAP PID
Volumetric Eff
Final Drive ratio


Thanks all in anticipation.

Elle B

[2i30s]

some of that info has been posted before,i think lorian posted it.   try doing a search.    [in the top left of the page]

[2i30s]

i found the frontal area , its 2.23 sq.m.   eyecon mentioned it for his g meter. is that what your using?   

[Dazzler]

 Hi Elle B ..

The one that Steve helped you with was probably the only one I would have been able to point you to.. but I will bring Trevors (surferdude) attention to this thread as he might be able to help with drag co-eff of the tyres..

Bot sure who could help with any of the others??

[2i30s]

Hi Elle B ..

The one that Steve helped you with was probably the only one I would have been able to point you to.. but I will bring Trevors (surferdude) attention to this thread as he might be able to help with drag co-eff of the tyres..

Bot sure who could help with any of the others??

possably eyecon. 

[Dazzler]

Sorry Elle B ... Had a chat with our resident Tyre Guru and can't assist with Tyre drag Co-eff unfortunately 

As 2i30's says a PM to eyecon might be your best source of info ...