i30 Owners Club

Diesel fuel filter change on i30 2015

0 Members and 1 Guest are viewing this topic.

Offline Dadsracing

  • 1st Gear
  • *
    • Posts: 4

    • gb United Kingdom
      Westmids
Hi I am about to service my 2015 i30  cdri tourer and need advice on changing the diesel fuel filter.
The filter is located behind the battery and ecu and does not have a hand primer on the top as on the earlier version.
I have attached an image to show it's location.
Any advise on replacement and priming will be a great help.

Thanks
Dad

  • i30 tourer cdri


Offline Dazzler

  • Admin
  • *
  • Laughter is the best medicine...
    • Posts: 67,423

    • au Australia
      Devonport Tasmania

  • Best Car Forum on the Net
Hi Dad and welcome..

You are probably more likely to get a reply about this from one of our Aussie crew and they are most likely still asleep. So hang tight.  :victory:
  • 2021 MG PHEV ( had 4 x i30 plus a Getz an Elantra and a Tucson)


Offline Paolo39

  • 2nd Gear
  • *
    • Posts: 88

    • gb United Kingdom
      Leicester
GD but has pump build in

:link: Hyundai i30 Fuel Filter Replacement - YouTube

In short:
- take out battery
- unscrew bracket that ECU is hold to chasis
- move ECU with braket to the side
- disconnect sensors and fuel lines coming to and going out of filter
- unscrew fuel filter with bracket
- take out of engine bay
- unscrew water sensor on the bottom (careful not to damage)
- when you undo sensor, be prepared to catch some fuel coming from filter
- unscrew the filter
- replace the filter
- put back everything in reverse order
- using fuel syringe prime the fuel
- connect outlet back and try to start engine
- check for leaks

In your case you need to use hand pump for diesel fuel - something like this:  http://www.hubitools.com/en/catalog/fuel-syringe~24eac614-7ab3-ef42-e647-39eabe20d30a- to prime fuel from filter
« Last Edit: July 09, 2019, 12:55:32 by Paolo39 »


Offline tw2005

  • Top Gear
  • *
    • Posts: 4,362

    • au Australia
      Ipswich
Factory level diagnostic tool also has an air removal function for this. basically runs the pump in the tank for 30 secs
  • i40 Premium Tourer, FD i30CW SLX CRDi FD i30 CRDi SX , Welly, SANTA CLAUS


Offline nzenigma

  • Top Gear
  • *
    • Posts: 4,070

    • au Australia
      QLD
Factory level diagnostic tool also has an air removal function for this. basically runs the pump in the tank for 30 secs

 Use 20mm of thin wire !!!!

Dad probably will not have that tool.
and Paolo's pump  link is RS

So he can just do the most practical thing : remove the fuel pump relay and use wire to briefly bridge the two PUMP contacts in that socket.
  • FD 2.0L CW (office); GD 1.8L & CRDi; BMW Z3 M; Audi A4 Quattro; Nissan 350Z HR


Offline Dadsracing

  • 1st Gear
  • *
    • Posts: 4

    • gb United Kingdom
      Westmids
Just go round to changing the fuel filter, easy job to do when the battery is removed (you can see more). Primed the filter when bab ib the car using a mityvac pump, enging started first pop. Fuel in the old filter was nice and clean, no bits or water so all good.
Thanks for your inputs.
  • i30 tourer cdri


Offline Dazzler

  • Admin
  • *
  • Laughter is the best medicine...
    • Posts: 67,423

    • au Australia
      Devonport Tasmania

  • Best Car Forum on the Net
Thanks for the update good to hear.  :goodjob:
  • 2021 MG PHEV ( had 4 x i30 plus a Getz an Elantra and a Tucson)


Unread Posts

 


SimplePortal 2.3.5 © 2008-2012, SimplePortal