i30 Owners Club

Location of Crank Angle Position Sensor in D4FB Diesel?

0 Members and 2 Guests are viewing this topic.

Offline InOzTas

  • 1st Gear
  • *
    • Posts: 4

    • au Australia
      Tasmania, Australia
I spent an hour looking around the engine yesterday, looking from above and below with the vehicle jacked up, and just could not find this thing. I see the Camshaft position sensor is on the top of the engine near the back, near the firewall but just cannot find the CKPS. Does anyone know where it should be on the diesel engine?
 
2011 i30CW wagon FD series, D4FB diesel engine.
  • 2011 i30CW FD 5 Door Wagon , Diesel 1.6lt, Auto, White


Offline NotAMechanic

  • 1st Gear
  • *
    • Posts: 2

    • sk Slovakia
If I remember correctly, it's at the back of the engine, on the right side, halfway down. But I can't take a look or picture because my i30 is in a repair shop.
  • 2009 FD 1.6 CRDi Manual & 2022 PDe 1.5 T-GDi MHEV Auto


Offline InOzTas

  • 1st Gear
  • *
    • Posts: 4

    • au Australia
      Tasmania, Australia
Hey @NotAMechanic thanks for your reply. I'll take a look tomorrow when I'm under the vehicle again.
  • 2011 i30CW FD 5 Door Wagon , Diesel 1.6lt, Auto, White


Offline InOzTas

  • 1st Gear
  • *
    • Posts: 4

    • au Australia
      Tasmania, Australia
Yep, thanks to @NotAMechanic I found it, as he said, looking up from underneath the vehicle, at the rear of the engine, it is on your left hand side, on the bell housing, about half way up.  the connector is accessible from the top of the engine, looking from the front it is on the right hand side clipped on to the side of the engine.
  • 2011 i30CW FD 5 Door Wagon , Diesel 1.6lt, Auto, White


Unread Posts

 


SimplePortal 2.3.5 © 2008-2012, SimplePortal